Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

Funny you should mention this. I had a few small circuit boards to cut up
just now and tried my sheet metal snips. It is a rather massive hand tool,
not the ones with the thin jaws. It cut through the FR4 easily and with good
control. When the ships are dull, it is easy to re-sharpen it.

Rick

-----Original Message-----
From: Homebrew_PCBs@yahoogroups.com [mailto:Homebrew_PCBs@yahoogroups.com]
On Behalf Of Mark Schoonover
Sent: Monday, December 17, 2012 10:54 PM
To: Homebrew_PCBs@yahoogroups.com
Subject: Re: [Homebrew_PCBs] PCB cutting

I've also have been looking for a better way to cut PCB material and I think
I've found it:

http://www.youtube.com/watch?v=3RyJHKz8LFU

Not only does it say "circuit board" on the outside box, it can also be used
to cut just about anything needed to make project boxes, etc.

73 - Mark Schoonover - KA6WKE
http://www.ka6wke.net

On Mon, Dec 17, 2012 at 9:37 PM, Richard <rdheiliger@...> wrote:

> Roberts Quik-Cut Vinyl Tile Cutter


[Non-text portions of this message have been removed]



------------------------------------

Be sure to visit the group home and check for new Links, Files, and Photos:
http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links