On Tue, 20 Nov 2012 14:43:22 -0000, you wrote:
>I am trying to convert my Eagle Board file to a Gcode to
>drill holes with my CNC mach. but I have been unable to
>contact anyone from PCBGCODE.com to get the latest version.
There's a yahoo group specifically for this, and John is active on it.
>Does it still exist or did they close up? In the mean time are there
>any suggestions of other inexpensive softwares I may use to do this?
I'd just join the group, you might consider the autoleveler software
addon, too. If you're using 6.x in Eagle, then make sure that you
have the fix for the measurement changes in the file structure.
Harvey
>Thanks,
>RL