| previous by date | index | next by date |
| previous in topic | topic list | next in topic |
--- In Homebrew_PCBs@yahoogroups.com, "RDHeiliger" <rdheiliger@...> wrote:
>
> Insulating the snap switch (temperature switch) from the aluminum heater bars will raise the temperature. On mine the snap switch is held on by a screw, put a piece of bare circuit board or cardboard on each side of the tab on the switch. Experiment with thickness till you get good results.
>
> RD
>
> [Non-text portions of this message have been removed]
>