Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: Need More Heat - GBC Laminator (pics included)

From: "RDHeiliger" <rdheiliger@...>
Date: 2012-11-11

Insulating the snap switch (temperature switch) from the aluminum heater bars will raise the temperature. On mine the snap switch is held on by a screw, put a piece of bare circuit board or cardboard on each side of the tab on the switch. Experiment with thickness till you get good results.

RD

[Non-text portions of this message have been removed]