Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

previous by date index next by date
previous in topic topic list  

Subject: Re: [Homebrew_PCBs] Transparent well-sealed plastic container & Edinburgh Etch

From: Robin Whittle <rw@...>
Date: 2012-09-04

I bought the set of three rectangular containers today for $4.95 at a
local shop. The internal dimensions are:

105 x 67 x 35mm 0.24 litre
140 x 89 x 45mm 0.5 litre
166 x 109 x 55mm 0.9 litre

The actual board size would be less than these since the corners are round.

It is probably not a good idea to leave etchant in them for a long time,
since the pressure on the seal and/or the etchant might damage the seal.

The stockist link at:


http://www.maxwellandwilliams.com/mw/maxwell-williams-storage-canisters-jars-snap-and-store-rectangular-container-ls3290.asp

leads to some distributors and retailers outside Australia, but I
couldn't easily find where they could be ordered online for customers in
other countries.

- Robin