i chimed in on this once before and it seems to me the obvious is go buy
some pipe, some mdf and a stepper kit from ebay and build a router, yuo
will be amazed at what else you use it for. if you repurpose components and
shop frugally youll have about 400 or less into it and it Will make you
money. just my .02
On Wed, Jun 27, 2012 at 8:18 PM, Harvey White <madyn@...>wrote:
> ∗∗
>
>
> On Wed, 27 Jun 2012 19:04:51 -0000, you wrote:
>
> >
> >
> >--- In Homebrew_PCBs@yahoogroups.com, Randall Morgan <rmorgan62@...>
> wrote:
> >>
> >> No, what I am describing is sending the step data not the GCode which
> has
> >> to be interpreted and compiled into step commands. It can be done using
> a
> >> RTOS but under a non RTOS it requires either extra hardware buffering.
>
[Non-text portions of this message have been removed]