Mike,
How wide is the blade you are using? I've used cnc to make pcbs, but
it isn't as easy as it might seem: Noise, dust, frequent tool
changes, uneven surfaces, etc. One thing I might be concerned about,
especially if the blade is very thin, is bridging when soldering. The
"traces: are varying widths, but the "spaces" are the width of the blade.
If the machine is capable of doing a second pass, you could try
either dragging a conical bit through the previous cuts or cutting a
second time with a very small offset.
Mark
At 01:29 AM 6/22/2012, you wrote:
>More on this subject. New Cut'n'Drill experiment video here
>
>http://www.youtube.com/watch?v=L14yUxxipfU&feature=player_embedded
>
>Next time I'll use a smaller drill (0.032" used here) and bigger
>pad/via sizes. This PCB was for all thru-hole devices. Will try SMD
>parts soon but that should be easier.
>
>Mike
>
>--- In Homebrew_PCBs@yahoogroups.com, Riley <rc3105@...> wrote:
> >
> > worked well enough when I tried it with a micro engraver (harbor
> freight 98227) and a cordless dremel (model 7300 from wally world)
> on FR1 machinable board blanks
> (www.inventables.com/technologies/circuit-board-blanks)
> >
> > --
> > Riley
> >
> >
> >
> >
> >
> > From: jeremy youngs <jcyoungs76@...>
> > Subject: Re: [Homebrew_PCBs] Re: Produce Quick & Cheap PCBs with
> a CNC paper cutter
> > Date: Wednesday, June 20, 2012, 6:56 PM
> >
> > i get the little light bulb picture above my head!!!!!!!!!! lol
> >
> > why not add a milling bit and use that to cut the pattern instead
> of the blade?
> >
>
>
>
>
>------------------------------------
>
>Be sure to visit the group home and check for new Links, Files, and Photos:
>http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
>
>
>