Guess someone has already done that: at least one guy on a DIY audio group
here in Brazil used to do some simpler boards by masking with plotter cut
vinyl, the same used on sign making. The trace width was large, as well as
spacing, and the board was single sided, but for simpler projects it should
work.
[ ]'s
2012/6/15 Bob Butcher <
bbutcher85@...>
> ∗∗
>
>
> Interesting topic. Instead of cutting the copper directly, how about
> cutting some vinyl or maybe masking tape? Then transfer the cut vinyl or
> tape to a copper clad FR4 board. Or maybe better yet, bond the tape or
> vinyl to the copper clad FR4 and then cut. Remove the unwanted vinyl or
> tape and etch the board. I have not tried this technique exactly, but have
> done a few boards with hand cut tape. If the etchant doesn't leak under the
> tape or dissolve the tape, it works fairly well. The trick might be to find
> the right tape, perhaps Kapton tape, or wide electrical tape?
>
> [Non-text portions of this message have been removed]
>
>
>
--
====================================
Daniel Washington S. Martins
e-mail:
dwsmartins@... - cel.: +55 31 9768-4368
[Non-text portions of this message have been removed]