Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

http://dl.dropbox.com/u/45620469/pcb/img_1356.jpg
http://dl.dropbox.com/u/45620469/pcb/img_1357.jpg
http://dl.dropbox.com/u/45620469/pcb/img_1359.jpg
http://dl.dropbox.com/u/45620469/pcb/img_1360.jpg

Works for me, but still breaks drill bits sometimes. Important thing is to
have some kind of slippery surface under the board, so board could slide a
bit if drill bit wants to center better in a pad. I am using a piece of
anti-static package from some electronic parts, the shiny one.

On Tue, May 15, 2012 at 3:43 PM, Howard <howard_g7lqy@...> wrote:

> ∗∗
>
>
> Hi All
> Am having some probs with my drill\stand setup.
>
> The stand is the type with a single slide piller,
> it is meant for a 240v work drill (i use a dremel drill )
> sometimes the stand will move from side to side and
> snap the drill bit !!.
>
> Can anyone suggest a good drill\stand combination, that
> will not give me these problems ?
>
> I think that some of you use Proxxon products
> any pros\cons ?
>
> Look forward for any comments
>
> Howard
>
>
>



--
KPL


[Non-text portions of this message have been removed]