On 15-Apr-12 03:51, David wrote:
> Leon / Andrew,
>
> Sorry, I dont think i made myself clear, I was suggesting the emulsion used in silk screen printing to be put directly onto the PCB using Craig's spinning method, not through a mesh, oven dry it, then expose using UV and circuit pattern on a transparency or tracing paper as normal, the exposed area would remain and the circuit washed off with water ready for etching, if that makes sense! I was also wondering if the resist would stand up to the etching chemicals? the main reason is, this type of emulsion is a lot cheaper and easier to get than the dedicated PCB stuff!
>
> David
>
Something like:
<
http://www.macdermidautotype.com/products/screen-films/capillex-films>
It was looong time that I used it to make screens for producing some
front panel foils. I may try someday :-) and feedback the findings.
--
Best Regards,
Zoran A. Šćepanović
zastos@...http://zastos.com+381 63 609-993
-..-
I may be a scwewy wabbit,
but I'm not going to Alcatwaz!