Ken,
I use a modified GBC laminator, and its limit is 165'C - 169'C [329'F -336'F], i put the green TRF and white TRF through two times and get good results, occasionally there are a few patches [especially over ground planes] that don't adhere, but thats probably due to fingerprint contamination!! are you able to adjust the temperature setting on your laminator? I cannot, but it works fine for TT and TRF.
hope this helps
David
--- In Homebrew_PCBs@yahoogroups.com, "sailingto" <sailingtoo@...> wrote:
>
> Hello all, the green film from Pulsar - what is the best temperature to run it thru laminator? I ran thru at 370ºF and that "seemed" like it "might" be a tad hot. It sorta "smeared" on a couple of close traces and I had to use a probe to clean before etching.
>
> Only 1 time thru?
>
> Thanks to all for any info,
>
> Ken H>
>