Make your own pulsed nitrogen UV laser with tow bits of bent aluminium and fresh air
For technical coverage of the UV Nitrogen laser, see:
<
http://spt06.chez-alice.fr/00/air.htm>
Malcolm
I don't suffer from insanity I enjoy it!
Mene, mene, tekel, upharsin
The writing is on the wall.
________________________________
From: designer_craig <
cs6061@...>
To:
Homebrew_PCBs@yahoogroups.com Sent: Friday, February 24, 2012 7:10 PM
Subject: [Homebrew_PCBs] Re: Novel way to expose photo resist??
Sage,
Go search the archives for Volkan, he did some great work on DLI using a blue ray laser diode mounted on a printer head shuttle. The immages resolution was stunning. The process was fairly slow because scanning was unidirectional. I think the pixel resolution was aobut .002" I would guess a 3x5 card would take 15 to 20 minutes to scan. He has also done a drum photo plotter in a similar manner.
Craig
--- In Homebrew_PCBs@yahoogroups.com, "drsage2007" <davesage12@...> wrote:
>
> Perhaps you all can comment on whether you think this flash from the past will work.
>
> Back in the day I used to plot PCB's using an old flat bed plotter with water proof ink in the pen. Getting the pens to work reliably and cleaning them was always a headache.
>
> All this talk about UV resist got me thinking - what if I were to mount a UV LED (laser diode?)with a lens or whatver it takes to focus a small dot on a board on the table and put it in the plotters pen hoder. I then coat the board with UV resist and let the plotter expose it. I might even be able to use the pre-sensitized boards.
>
> It plots really fast so I'm not sure how much time is required to expose the resist. But some of the LEDS from CD burners can apparently burn paper so given that the exposure is an intensity vs. time sort of thing it might work.
> The pen-down signal could easily be used to activate the LED and not much modification would be necessary to the plotter.
>
> I have an old Roland DXY800 plotter which for some strange reason is still supported by Eagle 5.xx so it creates files ready to go to the plotter.
>
> Any comments on if this would work?
>
> Sage
>
[Non-text portions of this message have been removed]