Hi Guys,
Just started to seriously look at the inkjet pcb idea, actually looking at a Artisan 50 and another on Ebay.
The plotter and UV laser can work. But, the downside is the cost of a UV 405nm laser head and controller.
Now the other option would be a 10mm diameter, 9,000 - 13,000mcd UV diode with a pin hole optical slit in front of it and some focusing optics behind the slit.
You can get UV laser diodes from Ebay.
http://www.ebay.com/itm/100-UV-10mm-LED-Ultra-Violet-15-Degree-Sharp-Angle-From-USA-/140678830209?pt=LH_DefaultDomain_0&hash=item20c11c9881This guy sells them in 100 piece bags, but you get the idea.
Best Regards,
Kevin I.
________________________________
From: drsage2007 <
davesage12@...>
To:
Homebrew_PCBs@yahoogroups.com Sent: Thursday, February 23, 2012 10:12 AM
Subject: [Homebrew_PCBs] Novel way to expose photo resist??
Perhaps you all can comment on whether you think this flash from the past will work.
Back in the day I used to plot PCB's using an old flat bed plotter with water proof ink in the pen. Getting the pens to work reliably and cleaning them was always a headache.
All this talk about UV resist got me thinking - what if I were to mount a UV LED (laser diode?)with a lens or whatver it takes to focus a small dot on a board on the table and put it in the plotters pen hoder. I then coat the board with UV resist and let the plotter expose it. I might even be able to use the pre-sensitized boards.
It plots really fast so I'm not sure how much time is required to expose the resist. But some of the LEDS from CD burners can apparently burn paper so given that the exposure is an intensity vs. time sort of thing it might work.
The pen-down signal could easily be used to activate the LED and not much modification would be necessary to the plotter.
I have an old Roland DXY800 plotter which for some strange reason is still supported by Eagle 5.xx so it creates files ready to go to the plotter.
Any comments on if this would work?
Sage
[Non-text portions of this message have been removed]