On Sat, 18 Feb 2012 16:22:15 -0000, you wrote:
>I had just purchased some Toner Transfer paper from Pulsar.
>Do any of you have any suggestions on the type
>of printer that you have had good luck with this product?
>I saw some one used a samsung laser 1200x1200 dpi with reg.
>photo paper. Any one else with sug?
I use an HP 2200D, in single sided mode, direct feedthrough (no
bends). Set the toner density at the highest possible (5). Still has
problems with large area fills, but works well enough.
>And any other tips on this product would be helpful.
Dunk the paper into water while still warm, do not let it dry out
since it may bubble and lift the traces. Hotter is better but too hot
can be a problem, test runs are good. Depending on the laminator you
use, you may want to run this through up to 8 times depending on the
board.
Harvey
>I tried the CNC way for a few weeks now, but there are to many
>problems, when dealing with such small traces.
>Thanks,
>Mark
>
>
>
>------------------------------------
>
>Be sure to visit the group home and check for new Links, Files, and Photos:
>http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
>
>
>