Dne 03. 02. 2012 23:02, pis(e Steve:
>
> Hi all,
>
> A couple of weeks ago I inquired about small drill presses for PCB work.
> I'm kinda leaning toward the Proxxon 38128. Looks like the drill press
> comes with six collets, the smallest of which accommodates 1/32in (about
> 1mm) shank size.
>
> I'd like to be able to use a #76 bit and perhaps a #78 bit with this
> drill press. Anyone know if collets are available for the 38128 for
> those smaller size bits? If so, what is the source?
>
This is not AFAIK meant for PCB work. It's for general-purpose work.
I use drill stand MB 140/S (NO 28606) + IB/E drill/grinder ( NO 28481).
Drill stand has extra bolt for elimination of air gap and it's very precise.
IB/E drill unit has high yuality bearings and can achieve high rpms,
needed for PCB drilling with hard drill bits.
Regards,
Branko
>
> Thanks.
>
> Steve K8JQ
>
> --
> Read The Patriot Post Vertitas vos Liberabit
> http://patriotpost.us/subscription/
>
>
[Non-text portions of this message have been removed]