On 02/01/2012 05:07, Piers Goodhew wrote:
> I've recently tried the "pocket" method, which DJ Delorie has mentioned here a few times: you line sides A and B up through a light and staple them together, then just slide the PCB in. My results were pretty close, but, oh, a few mil (< 10,>= 5) out - which could be due either to either the alignment or the (non)-perpendicularity of my hand drilling or both.
I've used that technique a couple of times, taping the two
transparencies together with masking tape folded over the edges. With
care, results aren't bad, but I find that single-sided boards with wire
links are quicker and easier to make.
Leon
--
Leon Heller
G1HSM