Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

Marc,

It sounds like we have been traveling down the same roads. I also used to
use Diazo for the final artwork but like you, I am hoping for direct
printing of the artwork.

I normally send out the artwork and get commercial boards made but for test
fixtures, RF striplines and other testing, a quick in-house setup would be
desirable.

Bertho



From: marc Sent: Thursday, December 29, 2011 21:43



Hi Bertho and all

for now my Dell 3010cn have good resolution on mg chemical paper
but on bright lamp dark area look Gray but uniform

i will try a epson NX400 soon (just need tu buy back ink cartrige)

i have order some microfiche diazo duplicator film
hope to be able to use laser transparency as master for the diazo
and use diazo for my pcb exposure like in bigger shop

but my final target was find printer that able to print quality
transparency that was good and reliable for 6 mil trace/space

Best regard
Marc Lalonde



_,___



[Non-text portions of this message have been removed]