Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: [Homebrew_PCBs] Cutter selection and/or hacks

From: Leon Heller <leon355@...>
Date: 2011-11-17

On 17/11/2011 15:43, DaveC wrote:
> This stuff is TOUGH! I scored with a utility knife, through the
> copper and well into the fiberglass. When I bent it over the edge of
> a table, it bowed a lot before finally breaking.

I use CEM-1 paper/fibre-glass laminate. It's ∗much∗ easier to cut and
drill than FR4.

Leon
--
Leon Heller
G1HSM