Is this to be used instead of a toaster ivan to set ink?
Mike KC7NOA
To:
Homebrew_PCBs@yahoogroups.comFrom:
leeleduc@...Date: Sat, 22 Oct 2011 14:06:53 +0000
Subject: [Homebrew_PCBs] Re: Harbor Freight Laminator
This laminator feeds faster than my GBC. It runs at 12 inches per minute. I ran my 2X4 inch board through it 8 to 10 times. I also let it warm up for about 30 minutes before using it.
--- In Homebrew_PCBs@yahoogroups.com, "nps0" <w6nim@...> wrote:
>
>
>
> --- In Homebrew_PCBs@yahoogroups.com, "leeleduc" <leeleduc@> wrote:
> >
> > Just tried a Harbor Freight 9" laminator (#92499) costing $28. The box it came in says it reaches 300 degrees. After a 0.032" board was run through a few times,it was very hot to the touch. Shows promise. I've posted a photo of my first try in the Harbor Freight Laminator file. The board outline is 10 mil in width. Looks like it may be a viable, inexpensive laminator.
> >
> > Printer used: Samsung ML-2525W
> >
> > Paper used: Staples Color Laser Paper #633215.
> >
> > I'm going to try this again when my Pulsar TTP arrives. Pulsar is the paper I usually use.
> >
> For what it's worth, I just got an HF coupon for this laminator for $19.99. For that price, I had to try it. I'll light it off tomorrow for a try. It's also cheap enough to take it apart and see if it can be worked over to accept thicker boards - I prefer to work with .062 stock. I can send copies of the coupon, if anyone else is interested.
>
> Norm
> W6NIM
>
[Non-text portions of this message have been removed]