Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

previous by date index next by date
  topic list next in topic

Subject: Harbor Freight Laminator

From: "leeleduc" <leeleduc@...>
Date: 2011-10-21

Just tried a Harbor Freight 9" laminator (#92499) costing $28. The box it came in says it reaches 300 degrees. After a 0.032" board was run through a few times,it was very hot to the touch. Shows promise. I've posted a photo of my first try in the Harbor Freight Laminator file. The board outline is 10 mil in width. Looks like it may be a viable, inexpensive laminator.

Printer used: Samsung ML-2525W

Paper used: Staples Color Laser Paper #633215.

I'm going to try this again when my Pulsar TTP arrives. Pulsar is the paper I usually use.