On Thu, 9 Jun 2011, schenckcharles wrote:
> Hi
>
> For the last few years I have been using Press N Peel with a Dell 1700
> laser printer in my home workshop. Results have been excellent, with
> little wastage of PCB material or etchant. However, most PCB artwork is
> amaller than a standard page and there are always scraps of the toner
> transfer material left over.
>
> I solved this problem by printing the artwork on a piece of plain paper,
> then rubber cementing a piece of the Press N Peel, which is slightly
> larger than the artwork, dull side up. Excess rubber cement is rubbed
> away from the edges. Then the whole gizmo is sent through the printer
> again. Rubber cement is removed from the shiny side of the Press N Peel
> Blue before ironing it onto the copper board.
>
> Just be sure that there is no traces of rubber cement on the sheet which
> could contaminate rullers inside the laser printer.
>
> Hope this works for all of you penny pinchers out there!
I thought everyone did something like that. It's in the Pulsar paper
documentation.
--
David Griffith
dgriffi@...A: Because it fouls the order in which people normally read text.
Q: Why is top-posting such a bad thing?
A: Top-posting.
Q: What is the most annoying thing in e-mail?