Hello Stefan,
05. October 2003, 12:48:56, you wrote:
ST> nice to hear there is some progress.
ST> your control setup sounds very interesting, but maybe a bit too complicated
ST> for me.
ST> (i hoped there are free dos based tools for parallel port drive available)
ST> have you done software research? what is available?
ST> i will check today - ignored the software until now totally....
ST> regards
ST> stefan
And I replied:
As for free (almost) software for driving CNC stuff over parallel port, you
can try TurboCNC. Registration is $20 and for that fee you will get the
source code. If you do not register, still you have a fully functional
software whic is not crippled in any way, and has no limitations.
Do a little Google, I can not find the URL at the moment.
--
Best Regards,
Zoran
mailto:
zasto@...