I had not considered about the issue with small boards - I would expect the rollers to be at least an inch or so apart? That would allow a board of at least 2"X3" to work.... maybe? BUT I have done a couple of boards less than 2" square... Hmmm, might be a problem.
I would like to hear from someone who has used one.
Thanks for the caution.
73 de Ken H>
--- In Homebrew_PCBs@yahoogroups.com, "tda7000" <Tda7000@...> wrote:
>
> Most toner only needs 170°C, this one can go to 200°C, don't see why it wouldn't work...
>
> The 4-roller thing has me worried a bit though, depending on how far apart they are it might be possible for a rather small board to get stuck inside...
>
> --- In Homebrew_PCBs@yahoogroups.com, "sailingto" <sailingtoo@> wrote:
> >
> > Has anyone used the Apache AL13P Professional 13" wide laminator? It's got 4 rollers, a digital temp readout up to 393ºF, and $80 shipped from below:
> >
> > http://tinyurl.com/3pa3mfs
> >
> > There is also an Amazon site selling for same price shipped.
> >
> > Comments anyone?
> >
> > 73 de Ken H>
> >
>