I also use magazine paper and it works great.
When I do it I also get white residue which I think maybe just paper fiber, or perhaps some kind of coating that was used.
The problem I have noticed with it is that it can obscure places where the printer made a hole, especially on large ground planes.
This makes the work of touching up problem areas a bit harder, but not impossible.
--- In Homebrew_PCBs@yahoogroups.com, "H1000100" <h500ca@...> wrote:
>
> There's a printer section in the database area. I will add my results as soon as I actually etch a board. So far, I'm finding that the Staples paper is unusable. Tried 3 times without success. This is disappointing because this paper leaves no residue on the toner.
>
> The magazine paper produced perfect transfers. Even the 6 mil traces transferred cleanly. However, it leaves a heavy white residue that looks like donut glazing under a 100x microscope. I don't know if it will produce pitted traces.
>
> I will post etch results as soon as I produce a properly aligned 2 sided pattern.
>