OK, I've uploaded a set of pictures which should be fairly self-explanatory to the Photo section folder "High temperature laminator rollers".
<
http://groups.yahoo.com/group/Homebrew_PCBs/photos/album/1380406873/pic/list>
Hope folks find it useful.
Dave
--- In Homebrew_PCBs@yahoogroups.com, "David C. Partridge" <david.partridge@...> wrote:
>
> There's not much to see really, apart from a possible shot of a completed roller which would be pretty boring.
>
> However, I do need to re-do the rollers as the write up I posted earlier was how it should be done. I got bitten by the length-wise shrinkage of the heat shrink, so didn't get PTFE coverage all the way to the ends. If there's enough interest, I could take pictures as I go and post a write up on my web-site.
>
> D.
> -----Original Message-----
> From: Homebrew_PCBs@yahoogroups.com [mailto:Homebrew_PCBs@yahoogroups.com] On Behalf Of tda7000
> Sent: 31 March 2011 22:50
> To: Homebrew_PCBs@yahoogroups.com
> Subject: [Homebrew_PCBs] Re: High temperature sleeves for laminator rollers?
>
> Sounds good! Do you have photos?
>