I meant £45 or so plus whatever we agree for a price ...
Regards,
David Partridge
-----Original Message-----
From:
Homebrew_PCBs@yahoogroups.com [mailto:
Homebrew_PCBs@yahoogroups.com] On Behalf Of David C. Partridge
Sent: 19 March 2011 17:40
To:
Homebrew_PCBs@yahoogroups.comSubject: [Homebrew_PCBs] FS: Ikon IP330 (aka Peak PP330) A3 laminator
I have one of these whose diode sensor based control board or thermostat had failed in the ON state, and has de-laminated front rollers and a blown thermal fuse.
The heated rollers are cheap enough at trade price of £16=25 plus VAT each (£20=31 plus VAT full retail), as is the thermal fuse at £2=60 plus VAT, both available from:
<
http://www.vivid-online.com/>
Total cost for those parts would be £42=12 including VAT.
The cost of the control board was however another matter - well over £30 for a small PCB with a transformer, some diodes, an opamp, a transistor, a relay and a few Rs and Cs.
I reverse engineered the control board (full schematic available on request) and have fixed it (replaced an LM324 op-amp).
Before I had the time to do that however I had already acquired another at a very good price ...
So it is for sale on the basis that for about £45 or so you will have a fully working A3 laminator with a retail of about £180.
Please contact me off list if interested.
Cheers
Dave
------------------------------------
Be sure to visit the group home and check for new Links, Files, and Photos:
http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links