Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

You need to use the cutting guide - read the instructions


Regards,
David Partridge


-----Original Message-----
From: Homebrew_PCBs@yahoogroups.com [mailto:Homebrew_PCBs@yahoogroups.com] On Behalf Of Alessio Sangalli
Sent: 18 March 2011 07:17
To: Homebrew_PCBs@yahoogroups.com
Subject: [Homebrew_PCBs] Table saw

Hi finally tonight I tried the table saw (Harbor Freight one) with the lopacki 8mil diamond blade.

Unfortunately, all cuts were not parallel:

http://www.manoweb.com/alesan/temp/tablesaw/test01.jpg
http://www.manoweb.com/alesan/temp/tablesaw/test02.jpg

Advices? I read I might have to go slower... will that do the trick? I used it wet. A bit splashy but no dust at all.

bye
as



------------------------------------

Be sure to visit the group home and check for new Links, Files, and Photos:
http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links