Update ...
I etched the board from this mornings cure in the oven.
I would say that it was also more difficult to clean the
toner off the board after etching. I didnt use acetone ..
Used a scouring pad. But that is what I have been using
so I wanted the same reference point.
Curing 2 more that way now ..
Will see how that goes ..
Jan .. hope it helps you ...
Randy
________________________________
From: Jan Kok <
jan.kok.5y@...>
To:
Homebrew_PCBs@yahoogroups.comSent: Sat, March 5, 2011 5:40:11 PM
Subject: Re: [Homebrew_PCBs] Toner curing
On Sat, Mar 5, 2011 at 1:30 PM, Randy S. <rj3819@...> wrote:
> I also saw a recent article on direct etchant transfer via
> inkjet printer. In that article, it mentions curing the toner
> after . Along with another article where a fellow feeds
> his pcbs directly thru a laserjet I want to say,
I'd guess it was an inkjet. Isn't there a problem with laserjet
(xerographic) printing to conductive surfaces?
> and said it works
> well if he cures the toner as well ..
>
> So .. I thought .. I have nothing to lose by trying ..
> So I cranked up the over to 260 ish degrees ..
> Put the board in for about 30 minutes ..
> ( all the time I had before leaving for work today )
>
> Quenched the board in cold water and dried.
Why quench in cold water? Just waving the board in the air would cool
it down in a few seconds.
> Took it into my shop and pecked at it with the scalpel
> again. All I can say is wow .. that seemed to have made a difference.
> Was a lot more difficult to scrap away any toner ..
Well anyway, it makes some sense to me to heat up the board after
doing the toner transfer. It would drive out moisture and, I would
think, make the toner stick better to the copper.
Maybe a hot air gun would also work, although the temperature couldn't
be controlled very well. It might be OK to heat up the board well
beyond the melting point of the toner. Just don't burn the board or
damage the adhesive that sticks the copper to the board.
Thanks for this report, Randy. I've also been having problems getting
the toner to stick well to the copper, so this idea may help.
> Thoughts ? Ideas ? no flaming me pse LOL
Why on earth would anyone flame you for passing on a possibly useful tip? :-)
- Jan
[Non-text portions of this message have been removed]