Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

previous by date index next by date
  topic list next in topic

Subject: PCB Drilling High RPM

From: "Bertho Boman" <boman33@...>
Date: 2011-02-26

Abount 15 years ago I did a bunch of PCB drilling. I used a low-cost air-turbine. Often it goes on sale at Harbour Freight and similar places for under $50 and the RPM is about 50,000 if I remember corectly.

It is mounted on a linear slide and activated by an air cylinder. Sorry about the dirty appearance, it has been in storage since then.

(What did Yahoo do to the picture?? It was perfectly exposed) Any suggestions how to avoid Yahoo destroying the pictures?
Bertho