Played a little more .. also need to leave PADS on ..
Looking good though .. thanks for the help
________________________________
From: Harvey White <
madyn@...>
To:
Homebrew_PCBs@yahoogroups.comSent: Sun, February 13, 2011 4:48:52 PM
Subject: Re: [Homebrew_PCBs] Eagle CAD Question
On Sun, 13 Feb 2011 20:05:47 -0000, you wrote:
>How do you print out just the foil side of a PCB
>using the software. I want to do just a single sided,
>thru hole board.
Turn off every layer except the bottom and the board outline. Print
that.
Eagle prints whatever layers are visible at the time.
Remember that the layer is reversed, if it's the bottom layer, which
is fine for toner transfer. For the top layer, you need to mirror it
yourself in the printout. Always include a word that must be read
properly to see if the layer must be reversed. ALL layers for toner
transfer must read reversed when printed. ALL layers for direct
printing (if used), must read correctly.
Harvey
>
>Thanks..
>
>Randy - N2CUA
>
>
>
>------------------------------------
>
>Be sure to visit the group home and check for new Links, Files, and Photos:
>http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
>
>
>
[Non-text portions of this message have been removed]