Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

I am trying to make PC boards using the laser printer/laminator technique.
I am using an HP P1102w laser printer, GBC H220 laminator and Pulsar
paper. So far I have used a couple of sheets of paper with nothing to show for
it except a dish full of floating traces. Has anyone else used this
method? I have the printer set at density 5 (max) and heavy paper (for the
Pulsar paper). I have run the boards through the laminator from 2 to 5 times
with little change in the results. The paper floats off the board along
with most of the traces. The circuit I'm trying to produce is an LM317
voltage regulator with about a dozen components. Suggestions would be most
appreciated.

Bill


[Non-text portions of this message have been removed]