Small change, I have the earlier H525, which for some reason seems to cost more. Smaller LCD display seems to be the main difference.
Speed 1 is very slow, it has reverse and stop, and max temp is 338F. I'm sure I could trick it into going higher but I will open it first to make sure the supports can take it. And I need to mod it a bit to allow 0.0625 thick boards.
Steve Greenfield AE7HD
--- In Homebrew_PCBs@yahoogroups.com, "alienrelics" <alienrelics@...> wrote:
>
> Wow! This is the laminator that I just bought for $15 from a thrift store:
>
> <http://www.amazon.com/GBC-12-5-Inch-Commercial-Laminator-1701620/dp/B000X0RIGQ/ref=sr_1_16?s=electronics&ie=UTF8&qid=1285032158&sr=1-16>
>
> $390!! Yikes.
>
> If it doesn't go up high enough, I figure I can gimmick the temp sensor as others have done here. Hopefully the internals aren't plastic.
>
> Steve Greenfield AE7HD
>