Ok I have enough of "score and snap" method (utility knife, glass
cutter, the best was the pen with carbite tip but still required too
much work) and the paper shear I have access to won't even begin to cut
the PCB material I have. So I followed the suggestion found on a old
thread, to get a 4" saw blade as I have found this one on sale at HF:
http://www.harborfreight.com/4-inch-tile-saw-with-wet-tray-3733.htmlNow, Baxter some time ago suggested this saw blade:
http://www.lopacki.com/sawblades/#fI just wanted to check it's the first one, "Fine Cut Diamond Saw Blade"
for 8 dollars. On the same page there is also a "Coarse Cut Diamond Saw
Blade" and a "Ultra thin" one
Thank you
bye!
as