Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: New GBC H65

From: "sailingto" <sailingtoo@...>
Date: 2010-07-28

I have the H-65 laminator and it handles .062" PCB material ok - by beveling the edges of PCB material it works just fine.

Without beveling sometimes a tad extra push is required to start the PCB into rollers, and they will "pop" a bit as the board exits the rollers, but doesn't seem to hurt anything.

I normally use .032", but do use .062" anything I need extra thick board, or if that's all I have.

Ken H>