When I have cut pcb material on my table saw I taped up a bunch, with
masking tape, and ran them thru so that the thickness would be at least a
half inch thru the cut.
I think a good table saw blade for this purpose would have many teeth, like
an 80 tooth diamond faced blade, which are available for 10 inch, which I
have and 8 inch, 12 inch, 4 inch I am not sure.
Some of the pcb material I think would not survive the table saw and a band
saw with a metal cutting blade might be better.
Sorry I cannot give a more precise response.
From:
Homebrew_PCBs@yahoogroups.com [mailto:
Homebrew_PCBs@yahoogroups.com]
On Behalf Of Ben L
Sent: Thursday, July 01, 2010 7:44 PM
To:
Homebrew_PCBs@yahoogroups.comSubject: [Homebrew_PCBs] Re: Circular saw pitch
--- In
Homebrew_PCBs@yahoogroups.com<mailto:Homebrew_PCBs%40yahoogroups.com> , "jimofc300" <jim@...> wrote:
>
> Hi,
>
> I just bought a Dremel Table Saw 580 (4" blade) on eBay. While waiting for
delivery, I ask...
>
> Can anyone recommend a proper blade pitch for cutting PCB fiberglass
boards? Should I get different pitches for rough and final cuts?
>
> I've heard that fiberglass causes a lot of wear on saw blades. Can anyone
estimate how many boards a blade can cut before replacement? Should I buy a
backup blade right away?
>
> I also plan to use it to cut aluminum up to 1/8" thick for chassis work.
Can someone recommend a good blade pitch for that task?
>
> Finally. since this is my first circular saw, I've looked for online
tutorials on safe and efficient operation. All I found were for 10" crcular
saws cutting wood. Does anyone know of a tutorial for little saws cutting
metal and fiberglass?
>
> Thanks,
> Jim
>
Get a Wet/Dry Diamond Blade.
Saftey: Most any of the Wood Workers rules would also apply to cutting
PCB's.
1. Keep your fingers away from the blade when running.
2. Wear Saftey Glasses.
3. Setup good Dust Collection.
4. Panel cutting jig that you can clamp your material to.
Ben
[Non-text portions of this message have been removed]