Not yet. I just redraw in KiCad. Most of my circuits are dead simple these days. No more than a half dozen components.
Donald.
--
"Plain Text" email -- it's an accessibility issue
() no proprietary attachments; no html mail
/\ ascii ribbon campaign - <www.asciiribbon.org>
----- "Frank P" <
qz9090@...> wrote:
> Donald,
> You said you "transfer" from KiCad to LTSpice, are you using an
> automated import/export utility to move the data between the apps?
>
> Thanks.
>
> Frank P.
>
> --- In Homebrew_PCBs@yahoogroups.com, Donald H Locker <dhlocker@...>
> wrote:
> >
> > I've been doing more simulation lately. Quicker than breadboard and
> the smoke stays inside the monitor. I like LTSpice a lot, so I'll
> enter a schematic in it, work out the kinks, transfer to KiCad for
> design and layout, then make a board.
> >
> > Donald.
> > --
> > "Plain Text" email -- it's an accessibility issue
> > () no proprietary attachments; no html mail
> > /\ ascii ribbon campaign - <www.asciiribbon.org>
> >
> > ----- "Frank P" <qz9090@...> wrote:
> >
> > > Leon,
> > > In looking at the KiCAD webpage
> > > (http://www.lis.inpg.fr/realise_au_lis/kicad/), it says:
> > >
> > > With the schematic entry, you can:
> > >
> > > ∗ Create simple or hierarchical sheets.
> > > ∗ Test it with the Electrical Rules Check tool (ERC),
> > > ∗ Create netlists for Pcbnew, or for Spice.
> > >
> > > So, I was wondering if people were using KiCAD and SPICE software
> > > together (and in what order). It sounds like you can use KiCAD
> and
> > > then run a simulation on SPICE software (maybe LTSPICE?).
> > >
> > >
> > >
> > > Frank P.
> > >
> > >
> > > --- In Homebrew_PCBs@yahoogroups.com, Leon Heller <leon355@>
> > > wrote:
> > > >
> > > > On 21/06/2010 17:57, Frank P wrote:
> > > > > In trying to layout a PCB, do you guys use LTSPICE to perform
> a
> > > simulation first? Then proceed to use a PCB layout software like
> > > KiCAD/FreePCB (after importing from LTSPICE)? Or, if the PCB is
> simple
> > > enough just start using KiCAD?
> > > >
> > > > You only need SPICE if you want to simulate an analogue circuit
> you
> > > are
> > > > using. Otherwise, just create a schematic and lay out the PCB.
> > > >
> > > > Leon
> > > > --
> > > > Leon Heller
> > > > G1HSM
> > > >
> > >
> > >
> > >
> > >
> > > ------------------------------------
> > >
> > > Be sure to visit the group home and check for new Links, Files,
> and
> > > Photos:
> > > http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
> > >
> > >
> > >
> >
>
>
>
>
> ------------------------------------
>
> Be sure to visit the group home and check for new Links, Files, and
> Photos:
> http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
>
>
>