I've been doing more simulation lately. Quicker than breadboard and the smoke stays inside the monitor. I like LTSpice a lot, so I'll enter a schematic in it, work out the kinks, transfer to KiCad for design and layout, then make a board.
Donald.
--
"Plain Text" email -- it's an accessibility issue
() no proprietary attachments; no html mail
/\ ascii ribbon campaign - <www.asciiribbon.org>
----- "Frank P" <
qz9090@...> wrote:
> Leon,
> In looking at the KiCAD webpage
> (http://www.lis.inpg.fr/realise_au_lis/kicad/), it says:
>
> With the schematic entry, you can:
>
> ∗ Create simple or hierarchical sheets.
> ∗ Test it with the Electrical Rules Check tool (ERC),
> ∗ Create netlists for Pcbnew, or for Spice.
>
> So, I was wondering if people were using KiCAD and SPICE software
> together (and in what order). It sounds like you can use KiCAD and
> then run a simulation on SPICE software (maybe LTSPICE?).
>
>
>
> Frank P.
>
>
> --- In Homebrew_PCBs@yahoogroups.com, Leon Heller <leon355@...>
> wrote:
> >
> > On 21/06/2010 17:57, Frank P wrote:
> > > In trying to layout a PCB, do you guys use LTSPICE to perform a
> simulation first? Then proceed to use a PCB layout software like
> KiCAD/FreePCB (after importing from LTSPICE)? Or, if the PCB is simple
> enough just start using KiCAD?
> >
> > You only need SPICE if you want to simulate an analogue circuit you
> are
> > using. Otherwise, just create a schematic and lay out the PCB.
> >
> > Leon
> > --
> > Leon Heller
> > G1HSM
> >
>
>
>
>
> ------------------------------------
>
> Be sure to visit the group home and check for new Links, Files, and
> Photos:
> http://groups.yahoo.com/group/Homebrew_PCBsYahoo! Groups Links
>
>
>