Does the widening only happen near the side of the paper that feeds in?
I'd be curious if you got better results by moving the pattern to the bottom
edge of the page, so the paper has plenty of time to be fully engaged in the
transfer roller before your pattern is printed.
-Andrew
On Mon, Jun 21, 2010 at 12:16 PM, Slavko Kocjancic <eslavko@...>wrote:
> I have same problem.
> Laserjet 1020 printer. The output in X is ok but on Y axis is terrible.
> Near all time is shorter by aprox 0.5% but two same prints doesn't gave
> same output. Ie if I print two transparencyes they does not fit exactly.
> I think the paper feed is not good. When printer grab paper they 'wigle'
> left and right little.
>
[Non-text portions of this message have been removed]