On 17/06/2010 11:41, sailingto wrote:
>
>
> I use a smaller size paper cutter, it works good on .032" and less. For
> .062" and .050" it does "ok", but really need to slide PCB out about
> middle ways so the board doesn't "twist" on cutting.
>
> Harbor Freight has two sizes, I have the small one, and am looking at
> getting the large one.
>
I've wondered about these paper cutters. Is it possible to apply enough
force to cut 1.6mm (0.062") material in the middle of the blade ? My
guess is this would put too much strain the paper cutter, but never
tried it myself. How close can you cut to traces without risk damaging
them ?