...... screen printing "on top" of the "micro-adhesive: may be an even better solution.
--- In Homebrew_PCBs@yahoogroups.com, "Richard" <richard.liberatoscioli@...> wrote:
>
> Hi gnuv!
>
> On a blank 8.5"x11"x1/4" Corian@ substrate, print out your component layout screen (lets say that's a 2.5"x3.5" finished module size) in the center of this substrate.
>
> Apply double sided (releasable) "micro-adhesive" tape/film over your printed screen (its "micro thin" and "see through").
>
> Apply SMDs with a vacuum assisted "pick and place" probe.
>
> When finished, stack on top your substrate the 8.5"x11"x1/4" Corian@ potting mold (with the 2.5"x3.5" square hole in the middle).
>
> Epoxy Pot to top of mold. When cured, release potting mold from substrate, potting mold is then flipped over, and run through the modified printer for conductive and insulative inkjeting.
>
>
>
>
>
> --- In Homebrew_PCBs@yahoogroups.com, "gnuvvekaavaali" <gnuvvekaavaali@> wrote:
> >
> > --- In Homebrew_PCBs@yahoogroups.com, "Richard" <richard.liberatoscioli@> wrote:
> > Something else I realized tonight, since the SMDs are "picked and placed" onto the "micro adhesive only"(no soldering) the SMDs can be placed "end to end" or "side to side" depending on the design of your schematic.
> > > >
> > > > For instance, 3 legs from my 64 pin QFN IC go to 6 capacitors, each leg going to two capacitors, then all caps go to vdd-.
> > > >
> > > > This normally would take 16 PCB tracks just to do this. By
> > > joining the SMDs "physically", soldered end to end without
> > > wires, from the top surface, I have now reduced my "printed
> > > wiring" down to just 4 connections. Similar printed wiring
> > > reductions are reflected throughout the entire assembly.
> >
> > Wow - very creative effort, indeed.
> > How do you ensure the accuracy of the SMD placement on the tape?
> >
>