--- In
Homebrew_PCBs@yahoogroups.com, Harvey White <madyn@...> wrote:
>
> On Mon, 24 May 2010 22:40:31 +0200, you wrote:
>
> >I think even with a single sided board the light shining through the
> >center of the pad might be enought to locate it depending on PCB
> >material. Or one could turn it over, of course.
>
I just drilled some boards last night. I did some experimenting with the position of the lamp and found that if I placed it behind the drill stand shining down on the board from the opposite side I was sitting, it was much easier to perceive the depth and the process went a lot quicker. I've finally actually managed to wear out a carbide bit, prior to building a specialized drill I always broke them before they ever dulled.