>think you can use a simple 8 pin micro with minimal other components
>(a diode and a bypass cap) to control the printer. When I get a few
>minutes I'll give it a try.
>
>Assuming this works, I'd like to offer a little board with the mcu
>already programmed to anyone who would like to give DLP a try. The
>cost will be minimal, should be under $5 USD. I only ask that you
>refrain from asking for one till you have purchased a printer and are
>serious about the project.
I'd like to buy one.Already bought the printer.
Meanwhile could you post the flowchart, to allow us to try write a
program, please?
Or the hex file for a PIC, as those are more common and the
programmers are widely spread.
Cristian
[Non-text portions of this message have been removed]