I agree, and I like that about this group. There's plenty of advise, but
nobody assumes you're doing it wrong if you're not using their method.
-Andrew
On Wed, May 12, 2010 at 8:20 AM, Piers Goodhew <piers@...> wrote:
>
>
> Wandering a little off-topic, but I'll keep it brief.
>
> One of the interesting things about this group, in my short time in it, is
> the almost complete lack of consensus - from CAD software to etchant, to
> TT/pos/neg/dry/wet, right down to the type of glue to use in a tank, they
> all get about 7 well-argued opinions pretty much covering the full spectrum.
>
> The lack of an FAQ or wiki or something and the relatively narrow range of
> topics used to puzzle me, but it's becoming clearer now.
>
> PG
>
> On 12/05/2010, at 6:02 PM, Eddie Stassen wrote:
>
> > The subject of cutting pcb's seems to pop up frequently and probably
> > should be addresses in a FAQ somewhere. I am always somewhat astounded
> > by the number of expensive/complex solutions offered for such a
>
>
>
[Non-text portions of this message have been removed]