Harvey,
Thanks for your input.
Some of the more elaborate solutions (table saw, band saw, etc.) seem like a bit "over-kill" for me, if I am only making a PCB once in awhile.
I believe Ian suggested using a 545 Diamond Cutting bit with a Dremel tool.
If I needed a large quantity, I would agree with you, i.e. outsource it. Of course, that leads to another question, who do you order them from? ...but, I think that is another thread of discussion.
--- In Homebrew_PCBs@yahoogroups.com, "Harvey McRae" <hlmcrae@...> wrote:
>
> Before you build your mini table saw, cut a few pieces by hand with the dremel.. I find that unless I'm running the Dremel tool at near top speed, it lacks on the power supply.. I don't think you would have enough power to do much cutting.
>
> Also doesn't Dremel have a little table saw attachment.? I think they do.
>
> Cheers.
>
> Harvey L. McRae
> 838 McKenzie Rd.,
> Kelowna, B.C. V1X2B3
> Phone - 250-765-1000
> Harvey's Cell - 250-808-4466
> Web: www.harriscreekcentral.webs.com
> ----- Original Message -----
> From: idbruce
> To: Homebrew_PCBs@yahoogroups.com
> Sent: Monday, May 10, 2010 6:29 AM
> Subject: [Homebrew_PCBs] Re: Best Way to Cut PCB
>
>
>
>
>
> Okay this is my first post. After trying several different methods with undesirable results, I finally tried something I read about on someone elses post elsewhere. For those of you who have a table saw, try using a metal cutting abrasive blade. After cutting pcb, use fine file to remove excess debris. This method worked well for me with satisfactory results. However I am thinking of creating a miniature table saw that uses a dremel rotary tool with a 545 Diamond Cutting Wheel. I believe this would be the perfect solution, but I have not tried it yet.
>
> --- In Homebrew_PCBs@yahoogroups.com, "Frank P" <qz9090@> wrote:
> >
> > There has been a lot of discussion centered on the laser toner transfer methods but how do you folks cut your copper clad sheets?
> >
> > Thanks.
> >
>
>
>
>
>
> [Non-text portions of this message have been removed]
>