Before you build your mini table saw, cut a few pieces by hand with the dremel.. I find that unless I'm running the Dremel tool at near top speed, it lacks on the power supply.. I don't think you would have enough power to do much cutting.
Also doesn't Dremel have a little table saw attachment.? I think they do.
Cheers.
Harvey L. McRae
838 McKenzie Rd.,
Kelowna, B.C. V1X2B3
Phone - 250-765-1000
Harvey's Cell - 250-808-4466
Web: www.harriscreekcentral.webs.com
----- Original Message -----
From: idbruce
To: Homebrew_PCBs@yahoogroups.com
Sent: Monday, May 10, 2010 6:29 AM
Subject: [Homebrew_PCBs] Re: Best Way to Cut PCB
Okay this is my first post. After trying several different methods with undesirable results, I finally tried something I read about on someone elses post elsewhere. For those of you who have a table saw, try using a metal cutting abrasive blade. After cutting pcb, use fine file to remove excess debris. This method worked well for me with satisfactory results. However I am thinking of creating a miniature table saw that uses a dremel rotary tool with a 545 Diamond Cutting Wheel. I believe this would be the perfect solution, but I have not tried it yet.
--- In Homebrew_PCBs@yahoogroups.com, "Frank P" <qz9090@...> wrote:
>
> There has been a lot of discussion centered on the laser toner transfer methods but how do you folks cut your copper clad sheets?
>
> Thanks.
>
[Non-text portions of this message have been removed]