I wonder if MicroMark sells small table saws?
--- In Homebrew_PCBs@yahoogroups.com, "sailingto" <sailingtoo@...> wrote:
>
> Harvey, you are correct - the PCB section that is cut off does not do well at all, unless it's pretty large - couple of inches maybe?
>
> Most all my boards are at least 1" to 3" in width, and that tends to cut off pretty good, but cutting a thin slice will just curl.
>
> If I had to do 15 or 20 boards I think I might opt for a table saw myself - being sure to use a very fine tooth carbide blade.
>
> In the PCB cutoff thread last week there was a really nice looking tiny table saw using diamond blade that looked like it'd do the trick.... If I needed 20 boards I think I'd seriously consider looking at a commercial offering.
>
> Ken H>
>