It would be nice if you could put it into the file or photo section of the group. Thank you.
Jean-Claude, Switzerland
----- Original Message -----
From: Roger Blair
To: Homebrew_PCBs@yahoogroups.com
Sent: Saturday, May 01, 2010 5:36 PM
Subject: RE: [Homebrew_PCBs] Re: Speed control for laminator motor
I am interested in this also, if you don't mind sharing.
Thanks,
Roger
From: Homebrew_PCBs@yahoogroups.com [mailto:Homebrew_PCBs@yahoogroups.com] On Behalf Of awakephd
Sent: Friday, April 30, 2010 07:38
To: Homebrew_PCBs@yahoogroups.com
Subject: [Homebrew_PCBs] Re: Speed control for laminator motor
Richard, what kind of circuit do you have in mind for the PWM? If you're wanting to do something with discrete ICs rather than a
microprocessor, I put together a PWM controller that allows for variable frequency as well as variable pulse width (true PWM) -- and
it only requires 2 op-amps or comparators, so it can be made with a single chip (not counting the drive circuitry). This may be a
common design -- I may have re-invented the wheel! -- but I couldn't find anything like this when I was needing this circuit. I
specifically wanted something that generated true PWM, but allowed me to vary the frequency so that I could choose the best
frequency at which to run for a given application. Let me know if you're interested.
--- In Homebrew_PCBs@yahoogroups.com <mailto:Homebrew_PCBs%40yahoogroups.com> , Richard Spelling <rls@...> wrote:
>
> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
>
> Went to bed tired and annoyed I couldn't easily find a slower gear motor
> for the laminator.
>
> Dreamed about building a magical speed controller that would let me run
> the existing motor infinitely slow.
>
> Realized I could use "temporal kinetic and thermal stabilization" since
> it's a worm gear motor.
>
> I.E., I build a standard PWM controller but set the frequency real
> sloowwwwww.
>
> Imagine having the speed turned down real low. Along comes a pulse. The
> motor spins up and turns the worm screw a revolution or two, then spins
> down. The board advances a fraction of an inch. An in-determinant amount
> of time later, along comes another pulse.
>
> Yes, it's "jogging" the board forward and not continuous motion, but
> between jogs it sits between the rollers long enough for the heat to
> transfer through the paper.
>
> I'm thinking about 10Hz.
>
> Whatcha think? Just another crazy idear from Richard?
>
> Now I just need to build the board.
>
> Wait a second, I need my laminator to build the board to fix the laminator!
>
>
> -----BEGIN PGP SIGNATURE-----
> Version: GnuPG v2.0.9 (GNU/Linux)
> Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org
>
> iEYEARECAAYFAkvZmXgACgkQ7R3zOzCoP9TDTwCgif7mfECp/31+fYq2RX/lkLca
> rcgAnjxf1FYgfzIrYMy3PBHKB2I1CcW6
> =z+Py
> -----END PGP SIGNATURE-----
>
[Non-text portions of this message have been removed]
[Non-text portions of this message have been removed]