What brand and model is it? Likely a large variance between brands and models. At what temperature is it heating at? Max? Charles AE5EW
--- In Homebrew_PCBs@yahoogroups.com, Henry Liu <henryjliu@...> wrote:
>
> Just another update: I've had this pizzaz pizza oven for over a month
> and I'm still very happy with it.
>
> This device I can stick my pcb on the plate and turn the dial to 8
> minutes then come back 10-15 minutes later and the board is done
> perfectly every time and the machine has cooled down. I have done
> over 20 prototype boards and each time it is set the dial to 8minutes
> from a cold start and walk away. The temperature is perfect and none
> of the plastic parts melt yet even big 470uF smd caps get solder
> perfectly. I can also watch the reflow process and push parts around
> if something is out of alignment with my dental pick.
>
> For $45 it is the best thing I bought since my $99 hot air gun station for PCBs.
>
> Search on walmart or amazon.com to get one yourself. I did replace
> the rotating plate with a solid 1/4" of aluminum that I had laying
> around.
>
> On Sat, Mar 20, 2010 at 7:15 PM, Henry Liu <henryjliu@...> wrote:
> > I have played with this more.
> > The original Pizzaz pizza oven comes with a 12" or so pizza pan that spins
> > around.
> > To know if there is a pizza pan on top, the unit has a small push down
> > interlock switch on the top. The motor turns with a small rotating motor
> > close to the front by using a shaft protrusion.
> > I did some modifications and now it works even better!
> > What I did was I put a 8"x6"x1/4" thick piece of aluminum plate on top of
> > the interlock but not cover the motor shaft protrusion. Now the unit turns
> > on but doesn't rotate. Also the entire plate is between the top and bottom
> > elements now.
> > The unit works great in this mode. I did more tests from a COLD start and
> > it reflows in 4:30 seconds - no hot air gun needed. There is easily enough
> > working space underneath to push parts around that moved out of place.
> > The unit is compact and easy to use. Great value at $45. It produces 1250W
> > of heating power through two heating elements and also has circulating fan
> > that pushes hot down onto the heating zone. Previously with the spinning
> > mechanism, it would not stay on one place very well. The power is perfect
> > so that it reflows but doesn't melt the board.
> > Previously I had a GE hot plate but this thing is 100x better. The GE unit
> > I used twice and never tried it again. This unit I will use everytime for
> > my small prototypes.
> > Henry
> >
>