On Thu, Apr 15, 2010 at 3:09 PM, Leon Heller <
leon355@...> wrote:
> On 15/04/2010 22:10, James wrote:
> >
> >
> >
> > You don't even need transparencies. I've used ordinary laser printer
> paper, a friend of mine has better results using tracing paper and laser
> printing on that. You have to make sure you print it so the toner side is
> against the board when you expose, and weight a piece of glass over it to
> hold the pattern completely flat against the board. Once you figure out the
> correct exposure time it can produce very consistent results.
> >
> > Bubble tank is easy, I built one out of acrylic but I've seen people use
> those narrow rectangular food storage containers with an aquarium air pump
> and heater. The heat is the most important part.
>
> When I used a laser printer for transparencies I got good results with
> tracing paper. I have heard of people putting cooking oil onto artwork
> printed on ordinary paper, to make it translucent. I tried it once, and
> it worked, but it was a bit messy.
>
> Leon
> --
> Leon Heller
> G1HSM
I went to my local $.99 store and purchased a cheap picture frame w/ two
pieces of glass. I used two plastic spring loaded clamps to hold my PCB
sandwich together. I find those clamps are perfect. I have heard the
tracing paper trick. I actually have those OH transparency sheets laying
around because I teach school. But I am stuck doing one at home I will give
it a try.
Is there a adjustment factor when using tracing sheets instead of
transparency sheets?
Thanks,
Chris Maness
KQ6UP
[Non-text portions of this message have been removed]