Leon,
My drill speed is 10,000 RPM. How fast do you think a proper speed should be? And what kind of sharp drill do you recommend?
Thanks
Lanny
--- In Homebrew_PCBs@yahoogroups.com, Leon Heller <leon355@...> wrote:
>
> On 11/02/2010 18:29, AnnonC wrote:
> > I'm looking for a method to deburr my ground vias to smooth the drill hole for copper plating. I do RF prototypes and the PCB has a lot of ground vias. In the past, I used 2 pass drill to drill the hole, the 2nd pass, one 1 mill smaller but it doesn't seem to help much. I can increase the diameter of the via hole up to 50 mils.
>
> Use sharp drills at the proper speed.
>
> Leon
>